Farmall & IHC Tractors Discussion Board |
300 U carb rebuild? Extra parts ?!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gerald on July 04, 2002 at 10:42:38 from (12.87.101.109):
I have my carburetor off and broken down. While doing this I found a ball (bb size) on the workbench which I am certain came from within the carb somewhere. I have the rebuild kit ready, but cannot figure out where this came from, if it really belongs in the carb, and what to do to get it back if so. My reprint I&T shop manual indicates a ball at #52 of the exploded view, near the choke stop pin. Could this be it? The carb plate is 36525R92, and the NAPA person indicated that this is an Internationl made carb., and not a Zenith or other. Seeing how I have some time over the holiday and would like to do something different than my desk jobI thank you in advance for your assistance so that I can get at the list.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|