Farmall & IHC Tractors Discussion Board |
Re: help on 806
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ejr on December 21, 2004 at 11:45:00 from (4.228.18.48):
In Reply to: help on 806 posted by Michael Earnest on December 20, 2004 at 23:50:30:
They will bolt up but their not long enough.Yes a 436 will bolt into a 806.I have a 706 thats going to have a 466.I have most every thing needed to do it .Two ways get a set of 66frame rails and the motor mount plate that will bolt into the 806.Use your front bolster but will have to shim between the frame rails and the bolster because the 1066 is a little wider than the 806.Or what Im doing is to use 806 frame rails redrill for the front motor mounts holes to match the 466 front motor plate which Ill narrow up to fit in the o6 narrower frame width.Also useing 560 hood because of its lengh the tractor will strech out a little needs the longer hood or use a 1456 hood its longer than a 806 hood.Also a cross over for the bottom radiator hose and throtle control moved to the left side.This takes care of most of the big stuff.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|