Farmall & IHC Tractors Discussion Board |
SW4 Electrical problem update
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by EddyJ on October 13, 2005 at 13:39:07 from (64.200.84.83):
Here is the update . It turns out the previous owner press fit a plug with a threaded end in the belt pulley attachment. It looked like a stud for the ground, but it wasn't. My connected ground to this wasn't good enough. Also there seems to be a short in the lighting system. I took the tractor down to only wiring the charging and ignition system. The system starts and charges fine.When I connect the lighting system wires get hot and it blows fuses ( someone put 30 amp fuses in this tractor) NOT GOOD. The wiring on this is a real bad job by the previous owner all homemade with lots of splices, not even close to original setup. ( I hate it when people dont have wire long enough so they use 2 ring terminals and a bolt then hide it under electrical tape and plastic conduit).Seen this more than once. I have a new harness but sending it in for paint first. Just wanted to make sure the system works . Thanks Jim for the insight into the problem. ED J
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|