Farmall & IHC Tractors Discussion Board |
Re: Magnum project- pictures
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JakeF on December 31, 2005 at 13:59:55 from (64.146.188.222):
In Reply to: Re: Magnum project- pictures posted by P Backus on December 30, 2005 at 22:23:03:
To get the old wear sleave off just take a chisel almost as wide as the sleave and hit it in two places a third of a revolution apart. It's hard stuff so you can give it a pretty good whack, and use one of your duller chisels as it's hard on them. It'll just pull off in your hand then. The installer can be had from cummins, case, otc, and miller. I borrowed one from Case and while I had it took down all the diminsions and had a local machinest build me one for 125.00 Jake
Replies:
Home
| Forums
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|