Farmall & IHC Tractors Discussion Board |
Re: Farmall A belt pulley removal question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Vern-MI on July 13, 2006 at 11:45:28 from (207.69.137.26):
In Reply to: Farmall A belt pulley removal question posted by Jesse on July 13, 2006 at 09:23:51:
Jesse about the only option you have is to drill and tap two places 180 degrees apart in the tapered bushing. Careful not to damage the shaft splines in the process. Then insert threaded studs and put a bar across those studs and use nuts on the studs to force the tapered bushing out of the pulley tapered hub. You may want to hit the pulley hub with some heat to encourage it to enlarge and release it's grip on the bushing. Not too much heat or the shaft seals will be damaged. The special splined tapered bushing is now scrap so it will have to be replaced.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|