You can use a loader from the port in your photo, but need to fix the arms and it is not very practical. It's better to use a valve to switch the supply from the link arms to your loader. If you remove the standard cover you see a pipe which comes from the pump. The pipe may come off with the cover, but it's safer to try to keep the bottom end connected. Connect a diverter in the same way as the cover you removed. (it may be wise to replace the rings) You can also get diverters with an integral spool valve. Extra spools can be bolted onto the side of the block. There are many types of valve, but the square blocks are more origional. The last photo is how I had my 135 with simple "trip" loader. The yellow lever switched between Link arms and loader, The Red lever was single spool to lift the loader and the white tap on the top allowed me to switch between the loader or rear external connection. If you already have the spool valves on the loader then you only need a simple diverter. To use the loader the quadrant needs to be set to constant pumping. The port high up under the seat is a return port although it is often considered too narrow for some applications. Many use either a port in the cover where PTO handle is or the filler cap. Second hand valves can be hard to find - but they are also available new. Hope this helps - Mike
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
