Tractor Talk Discussion Board |
Finish mower on a Johd Deere M????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pat Cox on April 14, 2002 at 04:11:44 from (207.199.164.41):
I recently purchased a John Deere M, to use with a grooming mower. I installed a Worksaver HK-201 three-point hitch adapter kit. The lift arms have a fixed 26” pull pin spacing. The problem I have is that the Land Pride finishing mower I wanted to buy won’t fit that pin spacing. Neither would a Woods. In fact, none of the three point implements on the dealer’s lot would fit that spacing. Does anyone use a John Deere M with the Worksaver HK-201 three-point hitch with a grooming mower? If so, what make and model? Has anyone found a boom pole and scraper blade that would work with the 26” pin spacing? Thanks in advance, Pat
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|