TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

706 Carb -- fuel not flowing? Solenoid? Forgetti

Welcome Guest, Log in or Register

Author

ZenBasser

05-19-2005 04:58:03

Report to Moderator

Forgive my double post -- but I can"t find the thread I followed up to -- it was an old 2004 thread and I think it may be in the archive....

I"ve got a 706 that sat for 1 -3 years. I"ve drained the gas --- it was total varnish. Emptied and cleaned the sediment bowl. Removed, flushed and cleaned the fuel line. Removed the carb, had it soaked, and new gasket, float, and valve. (But not new solenoid)

I can turn the 706 over -- and with small amounts of gas manually poured in the carb -- it will run -- but it"s dying as soon as that gas is gone.

I"m probably forgetting something obvious - but is maybe the solenoid got the gas shut off?

(yes, I"ve opened the gas at the bowl -- and gas flows well through the line up to the carb.

What am I forgetting? What next?

Thanks

[Log in to Reply] [No Email]

ZenBasser

05-20-2005 18:04:28

Report to Moderator

Re: 706 Carb -- fuel not flowing? Solenoid? Forg in reply to ZenBasser, 05-19-2005 04:58:03

Thanks.

Your tips and a replacement wire to the solenoid was the fix. It fired up and I used Ol' Red all morning! The operator's manual I ordered herre arrived yesterday.

Life is good. Thanks again for the quick help.

[Log in to Reply] [No Email]

the tractor vet

05-19-2005 08:32:25

Report to Moderator

Re: 706 Carb -- fuel not flowing? Solenoid? Forg in reply to ZenBasser, 05-19-2005 04:58:03

If ya don't hear a click when ya turn the key on first check and see if ya got juice at the wire if ya do then get a new selionde don't just replace with ah screw in main jet screw as it will cost ya in the long run when hot they don't like to shut down and most times people set them to lean and lean is mean .

[Log in to Reply] [No Email]

Joan Buraglio

07-10-2005 09:09:06

Report to Moderator

Re: 706 Carb -- fuel not flowing? Solenoid? Forg in reply to the tractor vet, 05-19-2005 08:32:25

Hi,
My hubby's 1963 706 has the wire removed from the solenoid. Where can I find a (reasonable) replacement solenoid for it?
Thank you!
JB

[Log in to Reply] [No Email]

El Toro

05-19-2005 05:27:50

Report to Moderator

Re: 706 Carb -- fuel not flowing? Solenoid? Forg in reply to ZenBasser, 05-19-2005 04:58:03

That needle may be gummed up from the vanish too.
Check the voltage with a volt meter at the solenoid. Hal

[Log in to Reply] [No Email]

Rich Griffin

05-19-2005 05:15:20

Report to Moderator

Re: 706 Carb -- fuel not flowing? Solenoid? Forg in reply to ZenBasser, 05-19-2005 04:58:03

You should have a clicking at the carb solonoid when you turn ign switch on and off,if not,bad sol.or bad wire, or dirty sol.needle

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy