Wiring 12v coil IH 263 6cyl,Switch w/push button

e-mail== jossejon@hickorytech.net

if 2 posts B and S the wire from the resis should come back the S side which goes to the push button.

3 posts. B--S--I the resis wire should go to the I post.

sorry bout that.

glad to help.

have fun with it

F on gen goes to f on reg

A on gen goes to A on reg

B on reg goes to positive on the amp

the way you had it wired it would spit and sputter because you had the coil resisted. two or three sparks and the resis would kick in and then nothing or very little.

take your time and NO swear words.
I do recomend 10 gauge wire for better performance.

have a good time with it

you do need a wire from the resis- Alt post back to the switch B side. i do this every day you would think typing it be would the same as doing it. not really.

what i do is run 10 gauge through out the system.
solid wire works the best but the extension cords work too. you can run the cord from front to back and it has a protective sheath.

black wire from key to resis
white from pos Amp to bolt on Alt
green from relay to pos on coil
red for the hot start connections.

sometimes they put on a cover with opposite polarities. so if you switch those wires and it does not start then switch them back. the triangle of resistance is alt - resis-key switch-resis - coil. if you only have one resis try running a wire from the bat cable post on the relay to the switch. the wire from the resis to the switch will now go directly to the pos post on the coil. there will be 2 wires at the pos coil post now.

ok one more time in english.
there should be a B and an S on the key switch.
from S on key to neg on amp to push button to S on relay.

bat positive cable to big post on relay and run a 10 gauge wire back to B on key switch.

R on relay to positive on coil

pos on coil to resistor then to Alt white wire.

red Alt wire to bolt post on back of Alt and from there to the positive on the amp

good luck

THE OTHER POST ON THE PUSH BUTTON WILL GO TO THE STARTER.

FROM THE POSITVE POST ON THE AMP
THE WIRE SHOULD GO ALL THE WAY TO THE BACK POST OF THE ALTERNATOR WHICH THE RED WIRE OR (2F) SIDE OF THE PLUG IN THE ALT SHOULD BE BOLTED ON.
THE WHITE WIRE OR (1R) OF THE ALT SHOULD GO TO AN ALT RESISTOR POST. THE OTHER RESIS POST GOES TO THE KEY SWITCH OPPOSITE OF THE 1ST WIRE.
RUN ANOTHER WIRE FROM THIS POST TO THE COIL RESISTOR POST( YES THERE IS A COIL RESIS TOO) THE OTHER RESIS POST GOES TO THE POSITIVE POST ON THE COIL AND THE NEG COIL POST TO THE DISTR.

GET SOME PAPER AND DRAW SOME CIRCLES WHERE EVERYTHING WILL BE AND FOLLOW THE STEPS. IF YOU HAVE ANY TROUBLE GIVE ME CALL