TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Ford 9N, 2N & 8N Discussion Forum

I'm a Doofus - part 2

Welcome Guest, Log in or Register

Author

9NJoe

09-24-2007 16:54:00

Report to Moderator

Well I ripped down my engine today and sure enough, the rod and crank are galled up bad. Think I can fix the crank and get the aluminum off but I am gonna need a rod and maybe a piston. Also found out what caused the oil to "disappear" seems the breather was defective and allowed all the juice to pump out over time. Note to self, check the oil every week instead of every season.

Joe

[Log in to Reply] [No Email]

soundguy

09-25-2007 05:29:56

Report to Moderator

Re: I'm a Doofus - part 2 in reply to 9NJoe, 09-24-2007 16:54:00

Sorry.. i missed the part where you id'd it as a different engine.

Still same info applies.. check oil before starting.. not weekly (wink).

soundguy

[Log in to Reply] [No Email]

soundguy

09-24-2007 17:59:22

Report to Moderator

Re: I'm a Doofus - part 2 in reply to 9NJoe, 09-24-2007 16:54:00

Note to self, check oil each time before you start!.. that's what the dipstick is for!

it's part of that precheck thing.. kick tires, turn on fuel, look into fuel tank ( put out cigar first )check oil, check oil in air breather, look at lugnuts, pull trans dipstick etc..

I take it you spun the main where the sheels galled to the crank.

Good luck on the crank.. hopefully it survived.

You can get recon rods here :

Rod wBushing, reconditioned - Fits 9N, 2N, 8N all with Gas. Recoditioned Piston Rod with Bushing. (Part No: 1201581) $72.12

Or good used ones at the smiths:

Good used connecting rods part number 9N6200. Fits all 9N-2N-8N tractors. $20 each - free shipping (48 states)

If your crank don't polish up you can get new or reground from here at YT.. or a used one that probably needs a regrind from the smiths.. good luck

Soundguy

[Log in to Reply] [No Email]

9NJoe

09-24-2007 18:39:39

Report to Moderator

Re: I'm a Doofus - part 2 in reply to soundguy, 09-24-2007 17:59:22

Sounder, Its my Briggs that ate itself, if it were my N I would be crying. I ALWAYS CHECH THE N.

Joe

[Log in to Reply] [No Email]

Hobo,NC

09-24-2007 19:30:53

Report to Moderator

Re: I'm a Doofus - part 2 in reply to 9NJoe, 09-24-2007 18:39:39

Whoooo!!! that's good if I could git $72 fer a rod I would go snatch one out of one of my runners fer ya and put a spit shine on it.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy