PTO extended through Hydraulic pump

Here is the shaft you are looking for.

I would hook into the tractor hydraulics myself. Just remember you will need to reconfigure the valve for closed center.

jt

• Long shaft

I think you will be happier hooked into the tractor hyd's than with the factory stuff like the dealership was looking at.

jt

what you are proposing will cause the pump to run all the time will cause premature failure of the pump. Also If memory serves me right the priority divider will cost more than the right loader valve from Surplus Center.

hth

jt

You can buy a PTO extension at any farm/tractor/implement dealer you walk into. 'Bout $35 the last time I checked.

Be sure and chain the pump to hold it forward and ya might want to install a drawbar extension also in some instances, depending on what you are pulling.

Allan

Early PTOs had a hole drilled thru 'em and the machinery PTO shaft was held on with a bolt.

Nowadays ya don't see that anymore, so you have to "chain" the pump forward to hold it and the extension in place. Then, your added implement will just snap on like usual.

They are a very tight fit to your PTO, so clean up your shaft good. Might have to "tap" the extension on with a light hammer.

You might see a tiny bit of "wobble" when you use one of these gizmos. Don't give it a thought. Darned thing only turns at 540 rpm anyway; not fast enough to even matter.

Allan

They have the extension shafts that will attach to the tractor's PTO shaft and pass through the pump, extending a standard PTO shaft length out beyond the pump.

They are a wholesale distributor, and MAY not sell direct to you, but SHOULD be willing and able to direct you to one of their resellers in your area, if necessary.)