|
| |
1967 Massey Ferguson Industrial 50 with Case Backhoe
Antique Tractor
 | | Here is the MF Industrial that I rebuilt with the help of Big Dean and Jack from the MF talk board. When purchased, the Perkins AD4-203 diesel was so bad that it wouldn't start in warm weather without ether. When torn apart, there was not one compression ring still in one piece. It purrrrrrrs now! I made the loader bucket, because it didn't have one. It was designed in AutoCAD and I torched the plate stock to the dimensions and welded together. I made adaptors and mounted the backhoe from a CASE 420B that I had onto the loader frame extensions. The front pump on the MF is a bit large for the backhoe and I have to run it slightly above idle to prevent 'slapping' it around too hard. The tires are 18.4' x 26' off of a combine that I bought at auction for 9.00! Submitted by Ken McWilliams, from OH |
Home
| Forums
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
