|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: I broke my holster on my 574
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike-IN on February 01, 2001 at 04:12:35 from (216.241.138.140):
In Reply to: Re: Re: Re: Re: Re: I broke my holster on my 574 posted by 80 grit on January 31, 2001 at 19:25:23:
The bucket was empty at the time of the incident and I was going uphill on Ice. (well within speed limits for the application due to going uphill on ice which hampered my progress). I was just "scratching" the ice to make it less slick. This setup has handled waaaaaaaaaaay more than what I gave it. I believe it was just one of those things where angles were just right to transfer the impact to the right area. Probably couldn't do ity again if I wanted to. I don't fill the bucket full of heavy items such as dirt because I feel the weight is too much for the front steering even though IH list/rates the 574 right in the middle of the size of tractor that this loader is designed for. There is generally alot of "slack" in the quick mounting system that takes up any typical impacts. I believe that this "slack" must have been reduced by the angles I was working with, etc..
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
