|
Farmall & IHC Tractors Discussion Board |
Re: B BN
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave BN on February 07, 2001 at 16:13:11 from (205.188.197.186):
In Reply to: B BN posted by Kurow on February 07, 2001 at 12:57:17:
My service manual shows the width of a BN is 47 3/8" and the width of a B is 55 3/8". This is measured from the pads where the drawbar bolts to the final drive. The axil housings on my BN are 18" long so the ones on a B would be 22"long. Not sure of the length of the actual axils, I'll keep looking. You can find the parts you need the question is the cost$$$$. Remember the right axil for the BN is the same as the one for the A which is much more popular and therefore more plentyful. I believe the left and right axils may be different on both B and BN as the brake drum is on the opposite side. Not sure though, may just be installed backward. Ill keep digging. Dave BN.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
