|
Farmall & IHC Tractors Discussion Board |
Belt pulleys that GROWLLLLLLL!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on February 09, 2001 at 07:21:37 from (216.183.128.2):
Another message on the board prompted me to ask this because i'm going to need to deal with this problem soon. My belt pulley make an awfull growling sound when you turn it by hand. I expected a bad bearing so I pulled it out and after my local I-H dealer told me how ,I put in new bearing and seals. I put it back on and gave her a spin...same growl. Iknow there are 3 shims at either end of the two shafts and the growl now must be that the teeth are not contacting perfectly. Do I play trial and error on these 6 shims? That makes 9 possible combinations of shims to set these gears and 9 times that you need to pull one of the two shafts. There must be an easier way to do this, but my manual only shows the configuration and talks about the teeth needing to mesh. I am looking for the easy way...HELP
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
