|
Farmall & IHC Tractors Discussion Board |
Re: Re: Battery Box Cover - What's it fit?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Poor Farm Jim on February 20, 2001 at 15:58:24 from (205.188.197.167):
In Reply to: Re: Battery Box Cover - What's it fit? posted by The Red With Pix on February 20, 2001 at 13:34:11:
Thanks guys, I even get a picture. Red, my lid is very similar but not exactly like yours. Mine is a flat top too, not beveled down on one side like the M lid. I meassured it VERY carefully and it is exactly 9 1/2 X 7 11/16 to the outside edges of the sheet metal. Also, the two rounded notches for the cables on mine are smaller and much closer together, with the one on the left being nearly centered and the one to the right of it being about 1 5/8 inchs away (center to center). And, while your hold down tangs are spot welded on the side of the cover mine are spot welded on the top and wrap around the side about 1/3 of the way and then stick out at a 90 degree angle, with the very ends of the forks sticking up ever so slightly. Hate to be a nit picker or pain in the butt about this. Could it be just a slight running change in covers for an H, or is it really for an A, B, C, Cub? Thanks Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
