Farmall & IHC Tractors Discussion Board |
Re: #24 Picker or Snapper?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Elden Denning on February 21, 2001 at 10:39:23 from (216.93.118.170):
In Reply to: #24 Picker or Snapper? posted by Poor Farm Jim on February 20, 2001 at 18:45:06:
The #24 IH mounted corn picker was not a picker for any day, any conditions picking. The early versions were really poorly designed and would "open up" if crowded hard or a rock or frozen dirt got run through it. Yes, the husking rolls were merely the upper part of the snapping rolls and didn't remove all the husks, and if the corn got really dry, you might see a few kernels on the ground, maybe a few "nubbin" ears even. But, to be fair, the later versions were much improved and experienced operators with good picking situations could do an acceptable job. Mounted on an H, a 24 made a decent outfit for the average size farmer, and not having to "open-up" the field was a big plus. In fact, when conditions were good, 24's did the job. When we got a SMTA we got a 2ME picker and yes, it did a helluvva lot better job, but the tractor and picker represented 3-4 times the cost of the H-24 outfit. And when you got that rig stuck, you had a serious problem. If you tried unplugging it with it running, it could get you too. I always shut them off and cut the cornstalks out with my jack-knife, it was a tough s-o-b sometimes, but I escaped with all my standard issue equipment. When I was helping my friend finishing his shelling last week I remembered those days in the late 40's and early 50's when we would flip coins to see who got to shovel the corn and who rode the picker/tractor--the winner usually shoveled.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|