|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Cub plow adjustment lever (part dimensions needed)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on February 25, 2001 at 21:30:32 from (64.254.131.89):
In Reply to: Re: Re: Re: Cub plow adjustment lever (part dimensions needed) posted by Wardner on February 25, 2001 at 19:27:46:
Wardner,
Thanks for the reply. We are talking about the same plow...just using different names for it. Sorry about your camera. It's the levers, brackets and latches to hold the plows up that are missing. I have a (gasp) John Deere tiller from a L & G tractor that I may put a separate engine on. Then I could rev it up while idling the tractor back. We'll see. Someone did a nice job posting the implement pictures.
George
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
