Farmall & IHC Tractors Discussion Board |
Re: Question on plowing.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Poor Farm Jim on February 26, 2001 at 11:04:24 from (152.163.195.198):
In Reply to: Question on plowing. posted by gibby on February 25, 2001 at 20:19:25:
Gibby, First, I have to say I wish I was living wherever you are, and out plowing. I still have 4 foot drifts here, and can hardly get around the yard as half of it is ice covered. You don't have diff. lock on your tractor. Your tractor pulling to the right has nothing to do with the furrow wheel getting more traction, that would pull you to the left. Think about it, if you could somehow cut the power to the left wheel what direction would it tend to go? The right one would push the tractor to the left. The point about adding weight or more weight to the left wheel is well taken, esp. if you are pulling 3 bottoms with a 300, you'll need all the help you can get. If all else fails - read the book. I'm sure it will start by telling you to set the right rear tire so the inside is 28-30 inches from the centerline of the tractor, depending on size of plow. After that follow the directions, it will tell how to correct the PLOW adjustment for pulling one way or another. I had two neighbors who were IH men. One guy and his son got one of the then new semi-mount plows and started plowing without doing any adjustments, just the way it came. They complained to the other neighbor about what a pile of junk it was and that they should never have bought this new fangled contraption. He told them to read the book and do what it said. They half heartedly made a couple changes and it plowed a little better. He was able to talk the son into bringing the tractor and plow over with the owners manual. They went step by step and did everything it said. It plowed like a dream, furrows looked like those in the ads. The old man bragged it up to anyone who would listen. Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|