Farmall & IHC Tractors Discussion Board |
Where does the HyTrans fluid go in an IH240?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rick on March 02, 2001 at 13:09:32 from (207.18.199.124):
I'm about to tear down the hydraulic control valve to fix a leak. I'm new to this so I have a couple of questions before I start. First, Where do I fill the system with fluid? I disassembled the filter assembly, but not sure how to add fluid. Also, how do I know when I've added enough fluid? Second, what is the capacity of the hydraulic system? I don't even know how much fluid I should buy. I have good downward pressure on the hitch, and very little, or no upward pressure. Looks like I have a leak at one of the gaskets in the control valve. I'm hoping this is the only problem. Has anyone seen similar problems? As always, any direction or advice will be appreciated. Rick,
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|