Farmall & IHC Tractors Discussion Board |
Re: NEED H MAG HELP!!!!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by speed bump on April 09, 2001 at 19:10:47 from (132.158.129.139):
In Reply to: NEED H MAG HELP!!!!!! posted by ThatOtherGuy on April 09, 2001 at 13:39:37:
Guy. as long as the base of the mag was not turned your timing will be ok. but you will still need to point the rotor to the right plug at tdc (top dead center). as far as no spark maybe try new condencer(capacitor), and secondly make sure the rotor is turning when you crank the starter , maybe your drive gear to the base of the mag is stripped . try again and ask here again if you dont find problem. speed bump
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|