Farmall & IHC Tractors Discussion Board |
WhatI don't know about clutches
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by William on May 11, 2001 at 10:05:27 from (12.77.221.38):
This much I think I understand. 'Free movement' is the distance the pedal has to be depressed before the release bearing makes contact with the fingers ('clutch release levers'). As the friction plate wears the fingers rise up and get closer to the bearing and the clutch pedal operating rod has to be adjusted to maintain the proper free movement. The manual states as clearly as it states anything that the rod has to be lengthened to increase the free movement. A previous post discusses a problem someone was having with too much free movement, that is, he had to depress the pedal all the way and it still did not completely release the clutch. He was told repeatedly and clearly to shorten the operating rod. That fits perfectly with the instructions in the manual. Here's the part I don't get: Mine doesn't work like that. My H got a new friction plate just before I got it, but the pedal was not adjusted. The rod that connects the clutch pedal to the shakt on the side of the housing is still near full extention. As you would expect there is too much free movement and the pedal has to depress all the way to make the clutch let go. If I shorten the operating rod that increases the distance the pedal has to be pressed to get the same movement of the release bearing. If I shorten it very much at all the entire range of movement of the pedal becomes 'free movement' and the release bearing never touches the fingers. I know this part because I just tried. I had to increase the length of the rod to get it to release. I'm usually pretty good at figuring out how these things work, but the longer I look at it this less sense the instructions make.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|