Re: f11 loader on 806

Posted by val jaspers on May 24, 2001 at 13:35:28 from (63.83.218.72):

In Reply to: f11 loader on 806 posted by shelly on May 23, 2001 at 18:21:19:

Had the same problem, blowing the seals, both front and rear, on the pump shaft. I have been told that this is a common problem when these pumps are getting worn and even after they are rebuilt. I solved the problem by taking a washer that fit over the shaft, drilled 4 holes at roughly 90 degrees apart through the washer and then placing the washer over the shaft with the new seal in place and drilling and tapping #8-32 holes in the pump just outside the seal. Be careful not to drill too deep. No problems since. Hope this make sense. If not, e-mail me at tractorval@hotmail.com and I could sketch a picture.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: f11 loader on 806 Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]