|
Farmall & IHC Tractors Discussion Board |
Inner soft metal ring replacement on Farmall H Front wheel Castings?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott S. on May 25, 2001 at 10:50:04 from (209.180.31.9):
I pulled the Front Wheel Castings off of the axles of my 1942 H lower bolster. The dust shields are in bad shape. Question: When the wheels are installed, a rim of soft steel protrudes from the front wheel casting and fits under the dust shield of the axle. Since it is made of soft steel, I would suppose it is not part of the solid front wheel casting. Can these be replaced? One looks to be fine, but the other is rather worn away. Are they pressure fit in? Can they be purchased new? What else should I replace while I am in there? Thanks for the info. Scott
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
