|
Farmall & IHC Tractors Discussion Board |
Re: Re: Unsticking Old Rusty H With Hydraulic Jacks??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Raider on May 25, 2001 at 13:59:20 from (192.105.235.146):
In Reply to: Re: Unsticking Old Rusty H With Hydraulic Jacks?? posted by Matt on May 25, 2001 at 11:45:46:
But if you can't get to both of the rod cap screws , you're out of luck. I have cylinder 2 & 3 in the 450 on a jack right now, and to protect the rods and crank, just a little upward pressure from the jack is resting on the crank. Pistons 1,2, & 3 are stuck. PB Blaster is everywhere.
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
