|
Farmall & IHC Tractors Discussion Board |
Re: Farmall H Pully for a belly mower
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on May 25, 2001 at 18:10:27 from (63.25.167.221):
In Reply to: Farmall H Pully for a belly mower posted by Rusty Jamison on May 25, 2001 at 05:39:10:
go to your woods dealer or go to someone who can get BROWNING they will have a listing for the hub that goes on the pto shaft then you will need a pulley about 24in dia for that hub this is what WOODS uses you have to have a big pulley as the pto only is 535 the A,B,and C all have right angle belt pulleys that run fast enough for the blades the pulley speed on these is around 1400 this is why the H will run of the pto and take a big pulley
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
