Farmall & IHC Tractors Discussion Board |
Sucess with removal of stuck steering pivot on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zonie on May 25, 2001 at 22:07:14 from (64.12.103.162):
This evening I finally got the steering pivot to drop out. I went to home depot and bought a lenght of 1" hardwood dowel and some copper 3/4" pipe caps. I cut the dowel to 8" in lenght and I sanded down the dowel to fit the pipe caps very snugly.The pipe caps keep the end of the dowel fron splintering and are soft enough to keep from damaging a steel shaft. If you can find 7/8" dowel they should fit perfectly. This made for a very stout punch to drive out the stuck pivot with out ruining the threads on the end. I did break a couple of these dowels driving out the pivot shaft but could reuse the copper caps. It's a good thing I bought a 3 foot dowel to start with. I think this tool could be useful for alot of applications where you need to drive out a shaft with out damage. The thrust bearing has large dimples in the top and bottom rings. I don't see how it could be functioning at all. Also the lower bushing has a large amount of play on the shaft, it rattles around. Neither the shaft or bushing show signs of excessive wear to account for the looseness. Any ideas where to get the seals, bushings, and thrust bearing? the closest Case / IH dealer is about 100 miles from here. I'm wondering if the Bearing supply house in town will have access to the thrust bearing. they should be able to get the seals and maybe the bushings. I'll have to try to locate a good sector gear and worm shaft as the gear had 3 teeth missing ijn the center of it and thid damaged the worm gear.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|