|
Farmall & IHC Tractors Discussion Board |
Re: 560 stuck in 4th or 5th gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thomas on May 26, 2001 at 05:41:41 from (205.188.197.167):
In Reply to: 560 stuck in 4th or 5th gear posted by Jeff on May 25, 2001 at 18:04:28:
I've had the same thing happen to me, had it stuck in rev. and 2nd at same time. by removing the shifter cover plate you can align the 3 slides back into neutral by using a pry or screwdriver. check the end of the shift lever before reassembly to see if it is severly worn causing it to actually move into neutral before disengaging for the gear it was in. The end of the shift lever should fill most of the neutral valley. If it doesn't you can weld the shifter to build it up and file it back down to the right size. worked for me about 3 years ago and haven't had a problem with it since. good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
