|
Farmall Tractors Discussion Board |
Re: 41 FARMALL A TIMING
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by kurt on February 16, 1999 at 13:27:56:
In Reply to: 41 FARMALL A TIMING posted by TONY on February 15, 1999 at 21:52:53:
tony
Its kinda simple hope i can explain it get no 1 cyl top dead center timing mark lined up in firing stroke {valves closed on it i take rocker off}. Line rotor to no 1 spot of cap put on with bolts crank motor over by hand till your there again dont go past it! then pull mag towards you until impulse coupler trips thighten it and your there.It might take a couple of times at first and you may not have the no 1 wire right. Good luck Kurt
Follow Ups:
Post a Followup
|
