Farmall & IHC Tractors Discussion Board |
Re: Farmall 100-Is it belly-mower ready?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on June 11, 2001 at 05:23:43 from (129.37.117.186):
In Reply to: Farmall 100-Is it belly-mower ready? posted by Bruce Haebe on June 10, 2001 at 22:03:48:
You need the belt pulley drive. You can use the PTO, but better to use the belt pulley. Most Woods mowers for this type tractor drive off the belt pulley. You do not need the rear rock shaft for the mower. The mower lifts off the front rockshaft that is in front of the steering wheel on RH side of the tractor. I would leave the liguid in the tires to improve stability. You could do without it on a level location, but if you already have it, I would leave it, especially if you do not have rear wheel weights.
Follow Ups:
Home
| Forums
Today's Featured Article -
Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|