Farmall & IHC Tractors Discussion Board |
Hot Hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on June 11, 2001 at 07:44:35 from (192.26.245.68):
Well after two months of weekends I got my first tractor (Model C) operational. Drained and replaced all fulids, replaced hoses, points, plugs, etc. etc. Got a lot of good advice from this group. Well being really pleased with how the old tractor was running decided to have some fun and mow the pasture. After about 45 min of mowing I looked down and noticed that there was smoke coming from the hydraulic control box behind the batt and the movement of the levers didn't do anything with the rocker shafts. I took the tractor to the shed and lossened the fluid filler plug. Steam and boiling fluid came out. I let it drain and cool then I replace the plug and the rocker shafts moved again. I finished mowing the pasture without further incident. Question, Was it too full or is there another problem someplace to worry about?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|