Farmall & IHC Tractors Discussion Board |
Pulled the B today....
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 1PWRFULH on June 30, 2001 at 13:40:08 from (63.25.40.19):
and had the most fun of my life! Boy, that is some fun stuff! Never pulled before either. I had one set of weights on the rear and one set on the front and she weighted 2,644. I think I either gotta get some off to be in the 2,000 class or put my other set on the rear which will get it close to 3,000 but in the same class. I gotta have at least some weight on it though for doing stuff around here. Put her in first and it sounded right with the straight pipe and wide open. The thing sounded the same when I hooked it up and right when it started spinning. The sled didnt even phase the motor so I think I can get along with another rear weight set and still be in the same class. Well just thought I would share my pulling experience with you. Take care RC
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|