|
Farmall & IHC Tractors Discussion Board |
Re: Reposting Thanks on Hydraulics with a couple questions, Please respond
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zonie on July 01, 2001 at 12:35:35 from (64.12.104.169):
In Reply to: Reposting Thanks on Hydraulics with a couple questions, Please respond posted by Lugaidh on July 01, 2001 at 06:54:32:
If I understand your question, you want to know what to do with the return from the cylinder?
On a one way system there is only one hose to the cylinder. It acts as supply and return both. there should not be a second hose connected to the cylinder.
If you have a cylinder with 2 ports you need to get an air vent plug for the unused port, if the cylinder had oil in both sides you need to get the oil out of the unused side... I found this out the hard way by getting a oil bath when I fully stroked the piston, the Air vent plugs hole was pointed right at my back when seated on the tractor. I got about a quart of oil all over me!
I'm including a photo of my hydraulic cylinder set up. It is connected only to the front port on the left side of the tractor. There is also a link for more pictures of this set up.this setup works very well.
I hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
