Farmall & IHC Tractors Discussion Board |
Re: Winch for 3 Point
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold Hubbard on July 07, 2001 at 05:18:47 from (209.198.117.29):
In Reply to: Winch for 3 Point posted by Ken T. on July 06, 2001 at 18:38:19:
There are a number of manufacturers who make 3 point winches. Farmi and Fransgard are two common ones, probably different depending on where you are. I have a home-made one which is built on a Farmi clutch system. These winches are fast and powerful, a great improwement over a chain, but a bit of a disappointment if you are used to a real skidder. Most of them hold 75 to 100 feet of cable, and will pull the tractor backwards if it's not set solidly. They incoporate a blade/stabilizer that prevents this unles you are on solid ice or frozen ground wher it can't dig in. This also keeps the tractor from turning over bacwards. The cable pulls from a sheave at about head height, and once the logs are wound in, the spool locks with a ratchet, and you can raise the unit and drive away with them. I have found that the load limit is about what you can lift with the 3 point. Depending on terrain you may be able to get away with a two wheel drive tractor with good chains. I use mine on a Massey 175. You will need lots of front ballast, my tractor has a loader, but I have found that a loader is not the best thing to be thrashing around in the woods with. Even with all that weight up front I still find myself steering with the brakes a lot. Unless you are working in really open flat terrain you really need rollover and overhead protection. If you are going to get really serious with it you should also have some sort of belly pan and radiator guard. Another important thing is to protect the tire valve stems, especially the rear wheels.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|