Farmall & IHC Tractors Discussion Board |
A fan shaft HELP
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Norman on July 11, 2001 at 17:01:06 from (206.206.120.103):
I needed a double pulley on the fan assembly so I could put a generator on a Farmall "A". I found one I took off a "B". It has the oil slinger on it. My book "IH Shop Manuel # IH-8" says it was used on the Cubs and Super "C". Any way, the manuel shows the slinger going one way. I put it on that way. She done went and froze up on me. How does that thing supposed to work? The flow of the oil looks like it needs to go the other way. How much end play should the shaft have? I find no way to decrease it. I have about 1/8 inch play. Hope someone can give me some relief. Thanks a million. Later Norman
Follow Ups:
Home
| Forums
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|