Farmall & IHC Tractors Discussion Board |
Re: Farmall A basic weight
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on July 11, 2001 at 19:34:29 from (63.25.166.31):
In Reply to: Farmall A basic weight posted by Rick B on July 11, 2001 at 04:42:01:
shipping wt from factory was less than 1600 you will have to weigh the one you have and go from there a lot of variables in tire size what type of discs in the wheels cast was standard on the drivers side but were avail with cast on both sides also pto and belt pulley batt starter and on so forth three different size rims were avail and front wheel fixed and adjustable also front axle fixed or adjustable might want to wiegh the front and then the back to see where you might want to go from there probably could get one down to 1500 if that is where you want to go enginewould easily turn 1700 or so can change the carb venturi also bigger jets check your rules first see what they will alow
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|