Farmall & IHC Tractors Discussion Board |
Re: FARMALL NB OR BN
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on July 15, 2001 at 18:44:17 from (63.15.137.152):
In Reply to: FARMALL NB OR BN posted by tedder on July 15, 2001 at 18:17:04:
THE farmall BN is 8in narrower that a B they did not have hy or a wide front someone is selling you something that was not built a wide front from an A can be put on there are three types of wide fronts that the A used 1-adjustable 2-non adjustable 3-industral type square tube with brace same attachments were used as on a B single bottom plow 2two-way plow 3 cultivator 4front mounted planter 4rear mounted planter 5 listers and some more stuff better be careful lots of people getting ripped off buying a piece of junk and representing it as something it aint or never was I happen to have two BNs one with a single bottom moldboard plow that uses the exhaust lift system so I am not blowing smoke
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|