Farmall & IHC Tractors Discussion Board |
Re: Hand clutch?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick (IL) on July 18, 2001 at 12:22:31 from (152.163.197.213):
In Reply to: Hand clutch? posted by Mark R. on July 17, 2001 at 19:03:49:
I have two friends who are in wheel chairs. One farms. Both have hand controls in everything they operate - cars, trucks, tractors, and a combine. The one who farms has lifts to assist him getting on the equipment. I believe a federal grant supplied money for those. The hand controls were designed and built by Royal Weber who owns Webber Welding in Nokomis, IL. Sounds like you need a tractor that is low to the ground, and the old standard treads would fit the bill fine, especially JD D, Case LA and 500 models. The platforms are low to the ground, all have hand clutches and, except for the 500, may have lever brake controls. Food for thought.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|