Farmall & IHC Tractors Discussion Board |
Hard start on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian on July 20, 2001 at 21:30:47 from (205.188.197.186):
My 47 H on 6 volts cranks nicely with new 2/0 cables and what seems like a decent battery but doesen't start till after a few trys and usally when you are pulling your thumb off the starter button. I re gapped it to .13 on # 1 TDC, and when it starts after a bit it purrs and idles great. This H has a mag that appears original and I touched up the caps contacts with sand paper. In my working on it today I put in the cap reversed and got it to start 180 degrees out of timing it ran ok on two cylinders with no power. My thought is that my original on - off switch is bad. I snap it on -off a couple time and it seemed to help a bit in the past. This could be luck though. I get spark at the plugs though it seems weak, I am used to 12 volt systems though. Any thoughts on how a H should start ? I had a 65 Mustang for a long time that I had starting before the key was on the contact for
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|