Farmall & IHC Tractors Discussion Board |
Re: Sickle bar sections....
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on July 22, 2001 at 13:16:59 from (128.242.4.59):
In Reply to: Sickle bar sections.... posted by Dave Catts on July 19, 2001 at 07:58:33:
Ussually you can get under or top serrated or smooth. The underserrated can be sharpened on the top with ease with a grinder but have a tendency to wear out guardes faster since the serration is at an angle. Top serrated sections are about impossible to sharpen since all sections should be sharpened on the top. Smooth sections are the easiest to sharpen but they may not stay sharp as long as the serrated. I preffer to use smooth sections and if I keep them sharp I don't have any trouble mowing prairy grass. Your guards however must have a good edge on them too. If they get a rounded edge on them even a sharp sicle is going to give you trouble. You can also touch guards up with a grinder by simply grinding a little off the side of them getting rid of the rounded edge. My pull type mower is 9 foot long and runs into a little expense to replace dull parts with new all the time so sharpening saves a little money. On a considerable shorter mower the cost of just buying new sections and guards would be a little cheaper since you don't have to buy quit so many. It is really just a personal preferance. I always sharpen and rebuild my own sicles to save money but I know others that buy new sicles and guards instead of farting around with the old stuff. I guess it boils down to if you want to spend a little money or if you want to spend some time working on it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|