Farmall & IHC Tractors Discussion Board |
Slow hydraulics - 3415
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Klaus on July 24, 2001 at 12:15:56 from (206.229.91.132):
So I've got my 3415 back together and the forward gears work again. It's actually useful now, but I'm finding the hydraulics very slow. Loader: It takes about 10 seconds to raise the front loader all the way. The owner's manual says it should take 5 seconds. Even 5 seconds sounds kind of slow - are these just just slow machines? As I understand from the parts manual, I've got a 17GPM main pump and a 9GPM steering pump. Does all of the steering pump's flow add to the main flow when not steering? I don't have a service manual. Power steering: The power steering works, but not really below 1000 engine RPM. There's a screw with T-handle in the front of the steering flow divider valve - does it force all steering pump flow to the steering system when screwed in? out? Or does it force the flow away from the steering system? I've changed the hy-tran fluid and suction and return filters. I found the bypass valve had slipped off the old suction filter. The wrong filter (not as tall) was in there, and the valve had been spaced out with a piece of PVC pipe. Also the fluid was milky white from water contamination.
Should I be looking for a stuck relief valve? stuck flow divider? Seems like the front loader has plenty of power (pressure). The backhoe is off currently, and the steering pump diverter valve that sends all steering flow to the backhoe is set to steering mode, I'm pretty sure that's not the problem. Sorry for the long post, Klaus
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|