Farmall & IHC Tractors Discussion Board |
Re: HELP front end M wobble!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by LarryG on August 08, 2001 at 04:16:01 from (63.113.79.11):
In Reply to: HELP front end M wobble!!! posted by Evan on August 07, 2001 at 08:32:45:
...It wasn't my question, but I'll say thanks anyway, Red. I have a front end loader on a '53 SM that I am restoring, and I have to replace the upper seal on the bolster which is drooling down the shaft. I don't have any wobble, but judging by how hard it steers, I'm anticipating that I'll find more than a weeping seal when I open it up. You're pic's were very timely. If the sector is badly worn, are there quality (new) replacements available? Thanks again - I read your posts even if it isn't a subject I'm immediately concerned with. You are one of the contributors that make this site an absolute gold mine for somebody who didn't grow up any closer to a tractor than making a few bucks as a thirteen year old tossing bales onto the wagon for the old dairy farmer next door.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|