Farmall & IHC Tractors Discussion Board |
504- 3Pt?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by S Clark on August 10, 2001 at 20:08:03 from (207.190.78.171):
I'm looking at a 504 that currently doesn't have any three point, two point, nothing except a drawbar. Did any of the 504s have a 3 point? If so, I'm assuming that under the cover of this one there probably isn't much so I would expect I would need the cover, inside plumbing/linkage, arms, etc. Would any other model IH covers and stuff work? Anybody know where I could find one and what should I expect to pay? Also does anyone know if there is an aftermarket model of 3 PT for the 504- cylinder lift of course? These seem to run 500-600 in my area for other models of IH, but can't seem to locate any in the books I have for the 540. I sincerely appreciate your comments about this adventure. This tractor will be used on my own little farm, a whopping 30 acres! Thanks for your comments
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|