Farmall & IHC Tractors Discussion Board |
Re: Re: newbie question: wide vs. narrow front wheels
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on August 25, 2001 at 12:16:06 from (128.242.4.59):
In Reply to: Re: newbie question: wide vs. narrow front wheels posted by jiM on August 21, 2001 at 20:58:54:
The original post here was about a tractor for the lake in wet and sandy conditions. I don't know how turning in garage or barn building came into play. Do you guys know each other or is there some bashing going on here? Hopefully I am not getting in the middle of something I don't need to be. Just read the post and thought I would add comment. Jim, you said your M will turn around in the garage and by your advice I gather it is a three wheeled version. Turning it around in your garage on a dry surface is alot different than in sand. I heard those 3 wheeled front ends were actually heavier than the regular 2 wheeled narrow fronts becuase of heavier castings. With one less wheel this will distribute more weight to even smaller area. In sand it will sink lower than a regular 2 wheeled narrow front. This will decrease power and perhaps even some manueverability. I still say a wide front is the way to go. I also believe a two wheeled narrow front is better in sand than a single front, a single front however would be better than 2 wheeled narrow front on solid ground. I am not trying to cuase any waves here but give us some factual info on how that single front is better in sandy or wet conditions versus a 2 wheeled narrow front or wide front. If you run on different surfaces there is a big difference in what style of front end you have and how you get around on that surface. On hard surface it doesn't vary much from one style front end to another except in turning and maybe a very little in power. You get in soft ground and the difference will set the different styled front ends way apart.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|