Farmall & IHC Tractors Discussion Board |
Re: Removing H Head Studs
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on September 03, 2001 at 06:57:19 from (63.27.17.189):
In Reply to: Removing H Head Studs posted by Zonie on September 02, 2001 at 18:21:48:
I am a big fan of welding nuts on flush breaks, and had to try 3 or 4 times recently on a transmission top plate mounting bolt. BUT when you give up, let the machine shop you take it to take out the stud. Don't break an easy out off in it. It is much harder to drill them, especially if your hole (and easy out) is off center. A good machine shop will line up the drill bit dead center of the hole to avoid damaging the threads, and will do all the drilling with left hand drill bits. Usually the stud will catch on the drill bit and back right on out before the last size hole is finished. If not, the original threads can usually still be cleaned up. Another lesson from experience, after you get oil, etc. worked into threads which will budge but not come on off, heating may coke the oil and freeze the joint up real good. I did this on a 3-point adjustable arm and then had to do a lot of heating and pounding to loosen the joint.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|