Farmall & IHC Tractors Discussion Board |
560 clutch problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J.D. on September 05, 2001 at 15:16:48 from (205.162.21.233):
On my dad's 560 the clutch doesn't disengage the engine from the transmission. I figure it's the clutch plate stuck to either the flywheel or the pressure plate. Is this just my punishment for parking it outside, or an indication I need to do a clutch a/o torque job? It did the same thing earlier this year, then got to where it was working again. T/A hasn't worked since he got the tractor. Last question, am I better off putting in a direct shaft that replaces the T/A? We've been doing without it for 20 years, after all. Thanks for any advice you can give.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|