|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: More on the 1066 not staying in reverse
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mitch Sisson on September 12, 2001 at 08:48:48 from (64.89.160.30):
In Reply to: Re: Re: Re: More on the 1066 not staying in reverse posted by the tractor vet on September 11, 2001 at 21:44:28:
I can't tell you how much I appreciate your help. If I thought you were anywhere close to Bellefontaine, Mississippi I would look you up! This site is wonderful! I never would have thought that there were good people on the net willing to give good advice about a tractor. I am sending some photos to your e-mail address. I will send each photo in a separate message. I know that some hotmail accounts have a file size limit. Thanks for all your help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
