|
Farmall & IHC Tractors Discussion Board |
Re: Super C.... Fouling Plugs
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on September 24, 2001 at 18:14:41 from (66.66.72.246):
In Reply to: Super C.... Fouling Plugs posted by Mark on September 24, 2001 at 17:40:50:
Les' advice is right on. But if you can't find D23 plugs, D21 (or AC C86) will likely do the trick (they did for me...) Other stuff to check: If you see any hint of black in the exhaust, the carb is set too rich and will quickly foul plugs - especially the two center cylinders. Lean out the power screw at governed speed, and the idle mix screw at idle until there's no trace of black. Make sure you have a themostat installed and it's working - a cold engine will tend to foul plugs over time. Finally if your ignition wires are carbon core (radio surpression or "resistor" type) throw 'em out and replace with plain copper core wires. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
