Farmall & IHC Tractors Discussion Board |
Re: Red, Bob M or anyone with valve advise
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pawnee on October 02, 2001 at 10:37:24 from (63.105.228.196):
In Reply to: Red, Bob M or anyone with valve advise posted by Paul Shuler on October 02, 2001 at 09:45:45:
Hi Paul - I have been working on my Super M for a while and just put new plugs, condenser, points etc. It had a constant miss that didn't seem to be ingition related. I am a complete novice at valve adjustment but i had a little help who showed me where to put the feeler gauge. We just did it with the engine off and cold. One valve had about half an inch clearance. Once we fired it up it ran smooth. Moral is that getting pretty close can be a big help. I was surprised such a simple adjustment made that big an impact. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|