Farmall & IHC Tractors Discussion Board |
Re: 3PT HITCH
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Moose on October 03, 2001 at 15:13:13 from (12.78.126.187):
In Reply to: 3PT HITCH posted by BPREAS on October 03, 2001 at 08:48:22:
Many years ago I found a 2 to 3 point adapter at a farm sale that was a bit different. Instead of installing a top link bracket to the rear of the tractor, this adapter has a bar that extends up to top link height and then back down to the other prong. You use either a short piece of chain or a fixed bar as a top link from the implement to the adapter, not to the tractor. It's real handy because you can just pull the two prong latches on the tractor and leave the whole adapter on the implement, ready to back into the next time you need it. Wouldn't be hard to make one yourself if you can weld and bend heavy steel.
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|